The development kit can convert the aircraft E-Port to multiple standard hardware ports such as XT30 power output ports, USB 2.0 port and UART/PPS signal port, making it convenient for developers to connect hardware equipment and perform SDK development and debugging.
1. To avoid short circuits caused by contact between the board and the aircraft arm, make sure the board is in a proper position when in use.
2. Be sure to design a heat dissipation system and a metal shielding cover if the adapter board is integrated into a load product.
3. Immediately disconnect the adapter board from the power source if sparks, smoke, strange smells or other abnormalities are detected.
4. When using all three XT30 power ports, the total power output will be less than the maximum power output of the aircraft. Be sure to develop loads within the specifications on the output.
E-Port adapter board × 1
Pin connector protection × 1
E-Port coaxial cable (150 mm) × 1
XT30 to USB-C power cable (300 mm) × 1
XT30 to DC5.5 power cable (300 mm) × 1
Adapter board dimensions: 55×40×9 mm (W×L×H)
XT30 VDC power output:
DJI Mavic 3E/3T: 12-17.6 V/4 A
30 series matrix: 19.2-26.1 V/4 A
300 RTK matrix: 24 V/4 A
350 RTK matrix: 24 V/4 A
XT30 12V output power: 12 V/2 A
XT30 5V output power: 5 V/2 A
350 RTK Matrix
Matrix 300 RTK
DJI Mavic 3E/3T